Reply To: Need some help- getting started guide or better information organization?

New Home Forum Updates Need some help- getting started guide or better information organization? Reply To: Need some help- getting started guide or better information organization?

#19640
Profile photo of Bill
Bill
Participant

Good job! Sounds like you are definitely heading in the right direction if you would like to take this thing up a level. I’m probably one of those people you mention. Though I’ve been looking at DIY CNCs for a while, this one is the first I’ve seen that wasn’t a conversion of something like the Harbor Freight tabletop mill. Your design is so much more versatile than any of those! My mind just spins with all the ideas as to what I’ll use it for, and I expect that what I end up doing isn’t even on my radar yet.

I think projects like these are going to drive a lot of the innovation over the next few years. It’s going to give almost anyone the tools to design whatever they envision.