Reply To: MPCNC Version 2 -opinions-

New Home Forum Updates MPCNC Version 2 -opinions- Reply To: MPCNC Version 2 -opinions-

#20857
Profile photo of Bill
Bill
Participant

I’m thinking of something like a swing pivot between horizontal and nearly vertical, if it pivots in the center of the long side it would likely only take up a 2′ x 4′ 6″ space when up and stretch out to a full 8′ 6″ x 4′ 6″ when fully flat. I’ve got a bit of a low ceiling in my garage/workshop since it’s a converted car port with my current workbench and the MPCNC on the tall edge, so if I were to build one I wouldn’t be able to go as close to vertical as that. Turning the deign sideways so it pivots on the short center would be easier to handle routing while vertical since the gantry would be across the short side, but it would take up a lot more floor space.