Reply To: MPCNC vs XCarve – Trying to decide.

New Home Forum Getting Started MPCNC vs XCarve – Trying to decide. Reply To: MPCNC vs XCarve – Trying to decide.

#20946
Profile photo of Steve
Steve
Participant

Thank you Wesley,

I appreciate the input.

I worked on a similar machine back in the dark ages (DanCad, parallel port connected drivers & ACME drives) and we went through several design revisions to accommodate larger and larger routers until we found one with enough juice to have decent cutting performance.

I had initially gotten the idea that the 660 only came with a 1/8″ collett. I just looked on Amazon and see one that has both 1/8 & 1/4.

I am beginning to warm up to the idea of the 660. I would still love to hear from those running the 611 and where I might find the mount for the 660?

Thanks again.

Steve