Reply To: MPCNC vs XCarve – Trying to decide.

New Home Forum Getting Started MPCNC vs XCarve – Trying to decide. Reply To: MPCNC vs XCarve – Trying to decide.

#21037
Profile photo of srcnet
srcnet
Participant

All the tubing I got was about 1/4″ longer than I asked for. As far as I know, that didn’t matter during the build. The rods can go a little over the corner parts. All the pairs were the same exact length though.

Overall I am happy with them. I had to cleanup the edges / cuts with a file since they were a little sharp.