Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#21147
Profile photo of Franz Maier
Franz Maier
Participant

Hello Mike,

I have a lot of false Endswitch messages within Estlcam. I have the endswitches connected normaly open. Tried a 1kOhm resistor, but this leads to a activated endswitch on the Ramps. What do you mean with +12V Ground? Are all GND’s not the same potential? I thought NO endswitches are not sensitive to noise, so I dont understand the false triggering.
Regards,
Franz