Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#21156
Profile photo of Big Jon
Big Jon
Participant

Hello all,

Thanks for all the information in this forum, I have learned many things.

I just reprogrammed my adruino mega2560 via the Estlcam 9.023 version, and used the values in Vicious post. I have everything hooked back up and Estlcam recognizes the board and gives me “CNC controller active” prompt, but I am unable to manually move the machine with the CNC controller window. I switched out the jumpers under “Z driver” and then replaced the driver back in place. I had full control manually with repetier host before, but thought I would support Christian and his project, as I’m excited about being able to control everything from one program.

I know it’s probably something very simple that I’m missing, thanks for everyone’s help in advance.

Jon