New Home › Forum › Software Development › Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support › Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support
I just re flashed with Marlin_16_32_090615_therm from Vicious, and I am back up and running off of Repetier Host. Therefore, I know that my boards and drivers are active and working. I will try and re flash with Estlcam and see if I can regain manual control over the board again.
If there is anything simple I’m missing, please don’t hesitate to let me know.
I really appreciate it.