New Home › Forum › Mostly Printed CNC – MPCNC › Your Builds – MPCNC › IT LIVES!!! Another one built – Melbourne Australia › Reply To: IT LIVES!!! Another one built – Melbourne Australia
Dremel 4000 mount by Fyleo
A bit fiddly to attach and uses M4, so another bolt size to keep track of – but works like a charm, rock solid. I used a spiral upcut / multipurpose cutting but that came in the kit; the tip is like a drill, not an end mill, but seemed to work just fine (softwood ply board)
Next, I need to track down some MDF slot board (probably an off cut from a shop fit out would be easiest to find here). Then software. Then I’ll try a trim router if I find the Dremel is not up to the task.