Reply To: Ramps 1.4 (X axis not moving)

New Home Forum Troubleshooting Ramps 1.4 (X axis not moving) Reply To: Ramps 1.4 (X axis not moving)

#21393
Profile photo of Simon S
Simon S
Participant

Hi
Just did another test on the ramps board.

Went through Bills tips, thanks.

Currently tested with one stepper motor with 4 wires.

X axis, moves once, possibly 1mm only on Repetier, and won’t move any further.
I swap the stepper to Y axis and swap the same driver from x axis to Y axis. I move the Y axis on Repetier and the stepper moves forward and backward.
I then wire the Z axis and move the Driver and I can move the stepper motor in Repetier back and forward.

Any input would be appreciated