Reply To: MP3DP step by step

New Home Forum Builds and Things Built MP3DP step by step Reply To: MP3DP step by step

#21552
Profile photo of Bill
Bill
Participant

And onwards!

5th image: Same old dame old, except the other side. You will notice I’ve been only peeling enough of the surface film off the routed pieces to uncover the needed holes, in an attempt to minimize fingerprints. In retrospect it would have been easier from the beginning to peel it all as I started on the new piece.

6th image: Z axis stepper mounts. Pretty simple and as long as you differentiate left from right you can’t get it wrong.

7th image: Y axis shafts, you really should only put the holders on one end to allow for assembly of the table sliders. I should have assembled the table sliders before placing them.

8th image: Install the LM8UU Linear Bearings in the table mounts then install on the Y axis shafts.

And on we go, four images at a time…