Home / Forum / Assembly / 4' x 4' possible? / Reply To: 4' x 4' possible?

Profile photo of alexpewpewalexpewpew
Post count: 11
#3179 |

her is one video https://www.youtube.com/watch?v=0bFK9dD4zVo and here is the other https://www.youtube.com/watch?v=jx7bP04f8M8 . I went for the corner brackets that add on, if i were to reprint the pieces i think i would edit the corners to include those so it prints as one piece. I like the easy way to adjust tension so I can figure out how tight I can get with out over doing it. With a smaller frame I don’t think I would need the corner brackets.

Thank you so much for the design!