Home / Forum / Software / Software – getting started / Reply To: Software – getting started

Profile photo of CurtCurt
Post count: 173
#3204 |

Christian – I found Marlin and GRBl and I could not get either to connect.

Vicious – When I set up Estlcam with Marlin firmware the files export with the .ncg extension which will not load in Repitier. Any suggestions? Also if you are using Repitier can your configuration?

all – I do not have a problem paying for software that I use but I am not certain Estlcam is the right product. Do I need to buy a license to continue testing?