Home / Forum / Assembly / Printed part preferred slicer / Reply To: Printed part preferred slicer

Profile photo of SteveCSteveC
Post count: 133
#3208 |

The latest version of slic3r 1.2.9 works pretty well. I used 0.3mm layers for everything with no problems and printed much faster than some of the print times mentioned here and on Thingiverse.

I did very light filing on some of the small bolt holes and some light sanding on the X and Y Rollers to tweak squareness. (My printer is a Kickstarter Robo3D with ED3V5 and an XXL LDC.)

Steve C