Home / Forum / Builds and Things Built / First 3D print / Reply To: First 3D print

Profile photo of KentKent
Post count: 7
#3583 |

The first few layers don’t seem to stick really well without the raft and if they do stick I get about 40% of the way through a print and it just pops off the bed and starts moving around.

The raft makes it stick hard the whole time, it’s even tough to remove sometimes when it’s done so I know it’s holding well.

I think I need to work on getting everything perfectly level, I’m pretty close now but my back right corner also comes up and won’t stick which is clearly a level issue since front left corner works great.