Home / Forum / Hardware / How to… connect / Reply To: How to… connect

Profile photo of arflemingarfleming
Post count: 14
#3690 |

I have found a solution to that in the firmware just by accident..

If you go to marlin firmware under “Configuration.h”
Look for this :
#define TEMP_SENSOR_0 0
#define TEMP_SENSOR_1 0
#define TEMP_SENSOR_2 0

Normaly the 0 at the end tells the machine there are sensors.. so the 0 can be a 1 or 2
Set these to 0 and errors are gone…
At least it works on hand mode… didnt try to let it run auto yet