Home / Forum / Builds and Things Built / 20×30 inch build / Reply To: 20×30 inch build

Profile photo of karltinslykarltinsly
Post count: 279
#3938 |

Meant to be test cuts, but they came out so well, we’ll probably use them! Really liking the carve feature of ESTLCAM. I’ve used a 1/2 inch 90 degree and 1/4 inch 60 degree bit so far. I’ve ordered a set of 10, 15, 20, and 30 degree bits for finer work.

Getting your z-zero correct is key, especially for carving. I find it’s better to be too deep that than not deep enough, so I usually set my zero a few tenths of a mm below the surface.