Reply To: X-Axis suddenly stopped moving in parallel?

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC X-Axis suddenly stopped moving in parallel? Reply To: X-Axis suddenly stopped moving in parallel?

#4098
Profile photo of SteveC
SteveC
Participant

Hey John, no worries at all. Karltinsly’s is really good description of an open in one of a stepper’s windings or connections. Just disconnect one of the stepper wires and you will see this when it is driven.

Did you set the driver current limit with this procedure? https://www.youtube.com/watch?v=89BHS9hfSUk . Just make sure you pick the proper equation for your drivers.

Steve