Reply To: Ramp 1.4 from kit Amperage and temperature error.

New Home Forum don’t use this one need to sort -Assembly – MPCNC Ramp 1.4 from kit Amperage and temperature error. Reply To: Ramp 1.4 from kit Amperage and temperature error.

#4148
Profile photo of Timothy
Timothy
Participant

Thank you both for the replies, I did read through and watch the video, but I had no idea which potentiometer to test or where to put my cables.

Ok Vicious, I actually tried both checked and unchecked before posting the first time. I just changed everything back but I’m still getting the maxTemp triggered error / invalid:?t extruder.

Some info that might help. Adding the resistor pushes the extruder temperature up +(500C)

When I add the resistor..
Extruder Temp status (575.6C)
Log:
18:53:04.349 : Error:0
18:53:04.350 : : Extruder switched off. MAXTEMP triggered !
18:53:04.356 : Error:Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)

When I remover the resistor..
Extruder Temp status (27C)
18:53:04.349 : Error:0
18:53:04.350 : : Extruder switched off. MINTEMP triggered !
18:53:04.356 : Error:Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)

These errors persist whether I change the Max Temperature in the printer setting.

Attachments: