Reply To: Ramp 1.4 from kit Amperage and temperature error.

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Ramp 1.4 from kit Amperage and temperature error. Reply To: Ramp 1.4 from kit Amperage and temperature error.

#4162
Profile photo of Timothy
Timothy
Participant

Thank you very much!

I was just reading up on how to flash the firmware and then I refreshed this page.
I just happened to buy “Make Electronics” Component kit and I have a few 100kOhm resistors.

Just put one on and the problem is solved.

Thanks Again!