Home / Forum / Software / Estlcam 2.5D tutorial? / Reply To: Estlcam 2.5D tutorial?

Profile photo of FrancescoFrancesco
Post count: 26
#4698 |

I’ve finally resolved!!!! I was enabled min_software_endstop on my Marlin, after disable it (and sure, i move my machine in the correct position and reset home) all go fine!!!!

I’ve tried to cut my first part and the result is…… very bad 😀 😀

In your video (https://www.youtube.com/watch?v=c8_lJPNWDwA) did you have used Roughing and finishing togheter ?

I’ve cut my all part with only finishing but in the last step, machine have started to cut a lot of material (0.5 mm!!!)

I think a tutorial on how make great part will be aprecited to all 🙂