Reply To: Estlcam 2.5D tutorial?

New Home Forum Software Development Estlcam 2.5D tutorial? Reply To: Estlcam 2.5D tutorial?

#4726
Profile photo of vicious1
vicious1
Keymaster

Put some calipers on your tool, is it 3mm exactly? Did you follow the estlcam walkthrough for all the basic settings like gcode output units?

Roughing step over shouldn’t be any higher than 45%.

Sounds like your z steps might be wrong, or wrong output units. Can you upload a picture, that makes it much easier to see whats going on.