Home / Forum / Assembly / Jamming conduit in to corner rails / Reply To: Jamming conduit in to corner rails

Profile photo of alanalan
Post count: 80
#4806 |


It’s coming alive….

Legs on, everything still loose to be squared up once I get the table ready and the machine down to the basement to my new “office”.

I’m hoping to get it “close” on level/square up here so I can hook the motors up and test electronics before I run too much cabling.

Then to let it sit on some rectangle cuts. I’m thinking something like a 12×20″ pocket at ~1mm depth per pass, maybe 15 passes. That should make it go around the rails at least a few hundred times.