Reply To: GRBL for RAMPS 1.4

New Home Forum Software Development GRBL for RAMPS 1.4 Reply To: GRBL for RAMPS 1.4

#4861
Profile photo of mschrock
mschrock
Participant

I’ve only tested the above code with Easel. I attempted to try Chilipeppr, but was unsuccessful. The only real advantage that I see is you aren’t bound to Estlcam, and are using firmware that is used with lasers, mills, and routers. Marlin is a 3D printer firmware and while based on GRBL, it is heavily modified for 3D printing.