Home / Forum / Builds and Things Built / Built one! Observations and lessons. / Reply To: Built one! Observations and lessons.

Profile photo of Asho777Asho777
Post count: 59
#4979 |

During a finishing pass I selected tool 2, by mistake.

The code has a M00 at the Finishing stage and Repetier run it with a problem. But I had no idea how to restart the code up again with Repetier. Even the LCD status was “Awaiting User”.

So all I did was select tool 1 for both the rough and finishing pass, and no M00 was generated, so therefore no issue as the code did not pause.

My question is how do you start the code back up after an M00, within Repetier?