Reply To: Built one! Observations and lessons.

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC Built one! Observations and lessons. Reply To: Built one! Observations and lessons.

Profile photo of Asho777

Well done Matt,

I will again setup a small run tonight, and see if the stop/kill button works to resume the job.

I tried the shuttle button, but that did nothing. The only other button the the stop/kill!

Reading the link you put up, it states that all motors are turn off! To me that is not a good way
of pausing a job. As normally to pause a job you need to do something, like change a tool, or filament
in the case of 3d printing. But if the motor are de-energized they will move very easy, and even a little
bump will cause a move in your paused position.

So I think I will look at the @pause command and see if that command keeps the motors energized?

Thanks for your efforts Matt.