Home / Forum / Assembly / End travel limit switches / Reply To: End travel limit switches

Profile photo of RichardRichard
Post count: 20
#5174 |

Karl, thank you for the feedback. I’ll be giving that a try.

Maybe you can answer a question? I hooked up my limit switches for moth x-min and x-max as well as for the y and Z. The Min switches are recognized but not the Max? I’m using pronterface on a Mac to test this out so perhaps that’s my problem. If I switch to the Estlcam, will these max endstops be recognized? Is there a different setting in the Arduino configuration i should be turning on?

Thank you for any help. Happy Holidays