Home / Forum / Builds and Things Built / T-Track / Reply To: T-Track

Profile photo of Matthew KennedyMatthew Kennedy
Post count: 17
#5250 |

Using printed T-slot, but I’m upgrading to some aluminum slot I found online.

What I’ve decided on is three channels running in the Y-axis on my 20×20″ spoil board, deep enough to withstand one or two resurfacings. Left and right of the spoiler I’ll place Y-direction tracks outside of the cutting area, and the same above and below in the X-direction, to hold the pieces that will be done in multiple cuts or are too large to clamp in the cutting area safely.

Good luck!