Home / Forum / Getting Started / Locking the steppers for tool changes / Reply To: Locking the steppers for tool changes

Profile photo of Matthew KennedyMatthew Kennedy
Post count: 17
#5286 |

Hi Karl,

When I say “Force” I’m usually talking about overpowering the Z stepper using the knob. I don’t want to crash the bit if I hit the wrong button, so I usually do the final Z adjustment by hand, I’m able to overcome the 64oz-in motor by hand pretty easily.

Attached is the menu nest where I was able to change the Gcode for the tool change routine:

Hope it helps!