Home / Forum / Builds and Things Built / Up and running! / Reply To: Up and running!

Profile photo of 3dTI3dTI
Post count: 70
#5353 |

Thanks mate. Milling was a success. Couple of small headaches aside.

Two quick questions.

Do you make available the vicious logo files? I wanted to carve/engrave one on my electronics enclosure?

Second. I’m still a little confused as to where to start/finish my cuts.

I’ve been starting the CNC programme ‘at origin’ and finishing ‘above origin’ in the setup in estlcam. Will this work, or will Repeater Host override these commands?

I have not attempted to run g code straight from a sd card yet. Does it simply things running straight from a sd card using the LCD controller?

Sorry if these are silly questions. I wish I had more time to spend experimenting and reading/learning. It seems there is never enough hours I’m a day lol.