Reply To: Stepper Driver Current Limit & parallel Stepper Motors

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Stepper Driver Current Limit & parallel Stepper Motors Reply To: Stepper Driver Current Limit & parallel Stepper Motors

#5364
Profile photo of Ryan
Ryan
Keymaster

It is pretty sensitive take the decimal further. 0.46v for the z, 0.93v the the others.

So now the cool part is you can over drive the hell out of the the steppers, if you have a fan or 2 on the drivers, so it is kind of an art. I would set them a bit low, .42, .85 and see what temps you get. The steppers can run at up to 100C (usually), although I would never do that. I run them at about 30C or less. I don’t like to push things too far so I ship the boards set at .42 and .7, no fan needed.