Reply To: My first CNC Build – MPCNC

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC My first CNC Build – MPCNC Reply To: My first CNC Build – MPCNC

#5454
Profile photo of Ryan
Ryan
Keymaster

Looks good, a giant one!

I know this doesn’t help too much but at that size I imagine you are planning on cutting a lot of thin sheets? I would cut the legs as short as possible, probably shorter than recommended. I’m not sure if you are too far into the table build but I made the bottom feet so the legs can pass through if you can drill some holes where the corners will mount. That way you can leave a little extra and move it up if you need too.