Home / Forum / Software / Software Chain for Laser Cutting / Reply To: Software Chain for Laser Cutting

Profile photo of Leo69Leo69
Post count: 337
#5577 |

I have a manual spindle speed controller on my MPCNC so I have no need for the M03 codes but I can see how some users would need to find a different approach. Using the M103 and M105 codes to drive a laser would interfere with extruder operation on a 3d printer too. I think Ramps users will just have to keep a set of firmwares on hand to flash depending on what they want to do with their MPCNC on any given day:)