Home / Forum / Software / Software Chain for Laser Cutting / Reply To: Software Chain for Laser Cutting

Profile photo of Leo69Leo69
Post count: 343
#5585 |

kartinsly: I was just looking at Jyech site and from what I’ve seen their laser set-up responds to M106 (w/S parameter) and M107 codes. Like you mentioned, if all else fails you can just take the image2gcode outpu and do a search and replace in notepad. Replacing “S” with “M106 S” and throwing an M107 (or M106 S0) at the end should work fine.