Reply To: Software Chain for Laser Cutting

New Home Forum Software Development Software Chain for Laser Cutting Reply To: Software Chain for Laser Cutting

#5946
Profile photo of Curt
Curt
Participant

@leo69 I agree that the extra values after teh decimal point will no likely make any difference. I know the P2L will work with my firmware but I do not know if the firmware uses those values.

@karltinsly – Thanks for the heads up on the plugin. It was EXACTLY what I was looking for.

I need to head back to laying a laminate floor and I will do the comparative burns later. Also I set the feed rate the same and tried to adjust the settings so they test is as close of an apples-to-apples test I can do.