Reply To: Software Chain for Laser Cutting

New Home Forum Software Development Software Chain for Laser Cutting Reply To: Software Chain for Laser Cutting

#5958
Profile photo of Curt
Curt
Participant

I finally was able to run the same image on both pieces of software. Both images are approx 1000x1000mm.
The settings:
Feedrate – 1200mm/min
Min 0 & Max 255

Original image
Original

PicLaser
PicLaser

Image2Gcode
Image2Gcode

The conclusions I came up with is the resolution on the PL software is a little better and that speed matters and it affects both a little differently. I do think the PL software is worth the money since it was only $40 but I do think with a little tweaking the I2G could work well.

I hope this helps