Reply To: Steeper motors dont manually work in repetier

New Home Forum don’t use this one need to sort -Assembly – MPCNC Steeper motors dont manually work in repetier Reply To: Steeper motors dont manually work in repetier

#6093
Profile photo of Kev
Kev
Participant

Thanks for the reply and I’ve now put 12V into both plugs. Repitier now starts to run the motor but the Nema 17 just whines and does nothing, the shaft of the motor is tight though when running but the motor doesn’t spin. Below is the model of motor I have:

Manufacturer Part Number 17HS19-2004S1
Step Angle 1.8°
Step Accuracy 5%
Holding Torque 59Ncm(83.6oz.in)
Rated Current/phase 2.0A
Phase Resistance 1.4ohms
Voltage 2.8V
Inductance 3.0mH±20%(1KHz)
Weight 400g

I know the voltage is 2.8V but I can’t get a 12V one rated at 2A, The link in the assembly section to the Nemas on Amazon show the same as above but do not display the voltage. Have I simply purchased the wrong motor. Thanks