Reply To: Steeper motors dont manually work in repetier

New Home Forum don’t use this one need to sort -Assembly – MPCNC Steeper motors dont manually work in repetier Reply To: Steeper motors dont manually work in repetier

#6094
Profile photo of vicious1
vicious1
Keymaster

what drivers are you using?

your steppers are 2.8v*2A= 5.6W so 5.6w/12v=.467A per motor needed.

use that figure to set your drivers. You are either over or under powering them. Make sure to do all this testing with no belts attached.