Reply To: Steeper motors dont manually work in repetier

New Home Forum don’t use this one need to sort -Assembly – MPCNC Steeper motors dont manually work in repetier Reply To: Steeper motors dont manually work in repetier

#6100
Profile photo of vicious1
vicious1
Keymaster

My firmware is pre-configured marlin. You should only be flashing mine. Your issue is stepps per mm, reflash my firmware if you are using 16t pulleys and you should be up and running.

video on setting the drivers in here, http://www.vicious1.com/assembly/ramps-wiring/