Home / Forum / Troubleshooting / Everything is out of scale / Reply To: Everything is out of scale

Profile photo of RichardRichard
Post count: 20
#6286 |

I loaded the beta firmware, I made sure my three jumpers are installed. Tried again and still got enlarged print.

I created a simple file with a square, circle and 2 triangles. The square is 80X80, the circle has a diameter of 65. The triangle is inside the triangle which is inside the circle.

When this prints/cuts, the square turns out to be 100X100 and the circle is 80. This means that the scaling is occurring on X and Y.

On one other note, the display didn’t come on. Should I uncomment line 601 of the Configuration.h module?

I greatly appreciate the help.