Home / Forum / Troubleshooting / Everything is out of scale / Reply To: Everything is out of scale

Profile photo of RichardRichard
Post count: 20
#6313 |

I’m using 2 different thinks. ESTLcam which I still haven’t gotten the knack for. I’m also using Easel. In both situations, the cut is scaled up about 125%. I can send you the file and see what you get when you run it.

I know that I’m extremely new to this so before going any further, I dug out all my orders and parts to double check that I’m matching your design.

Arduino MEGA 2560 R3
I’ve upgraded to the new Beta
RAMPS1.4 for RepRap, Mendel, Prusa Came with the A4988 drivers
I’ve upgraded to the DRV8255 drivers
using NEMA 17, 2amp, 84oz, motors
6mm GT2 belt
Pulleys, OOPS. Looks like I goofed this up to. Looks like I got 20 tooth instead of 16.

Guess I figured out why I have a 125% enlargement. Looks like I need to make another order for a set of pulleys.

Thank you for your patience, I’ll be in touch after I get the new pulleys.

On a different note, I used the B16_32_fullG-112515 firmware. I think I need to switch to the B16_32-LCD-112515. I’ll try that and let you know if that works as well.

Is there any setting I could use for the 20 tooth gears until new ones arrive?

Thank you