Reply To: MPCNC 2.8w $100 laser add-on complete

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC MPCNC 2.8w $100 laser add-on complete Reply To: MPCNC 2.8w $100 laser add-on complete

#6661
Profile photo of Tony
Tony
Participant

Sorry, I mis-spoke. I set the current at 1.7 Amps. I did move it down to about 60mm in the above picture. Yeah, I’ve been adjusting the lens at a few different heights. Not much difference. I’m going to go try again shortly. I’ve also checked the lens to be sure it wasn’t dirty. No, the first one wasn’t a ndb7875.