New Home › Forum › Software Development › Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC › Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC
Thanks for your prompt replay, unfortunately the generated Gcode is too big to be uploaded on here. I’m sorry but I did’t know that Repetier can not display any detail of the raster image. I’m using a 500 mw blue-violet 405nm laser module and I guess that if the power will PWD under 50/60% it will not burn any material, may be this is the problem when I burn the Gcode generated by image2gcode and I guess It’s better for my 500 mw laser to use MAX or Anodized Aluminium profile, isn’t it? Is also useful or not to allow feed rate override?
Thanks again for your kind help.