Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

New Home Forum Software Development Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

#6861
Profile photo of Leo69
Leo69
Participant

This thread is specifically about image2gcode software which DOES allow origin setting, thanks to Bryan’s revision. The code you posted is specific to pic laser which i believe does NOT allow origin setting. That’s a Jtech software package so maybe someone here uses it and can answer otherwise maybe Jtech forum? Also, why dithering? Does your laser support regular raster/TTL engraving? If it does then give image2gcode a try.