Home / Forum / Builds and Things Built / Up and running! / Reply To: Up and running!

Profile photo of 3dTI3dTI
Post count: 70
#7013 |

It’s such a lovely material to print. I’m especially impressed by its layer adhesion!

Price wise I found it quite reasonable. Au pricing was $49.95 per 1kg for the PETG $59.95 per 450g for the nylon and $49.95 per 450g for the Polymax.

Bang for buck I think it’s some of the best value filament available. I probably would have gone with the alloy 910 if the price was better, but so far the PETG is performing admirably.

I still may print some of the higher stressed parts in nylon (middle assembly and motor mounts maybe) as I still have an almost full roll on hand.