Home / Forum / Troubleshooting / 3d Print troubleshoot- / Reply To: 3d Print troubleshoot-

Profile photo of mark leinomark leino
Post count: 35
#7102 |

Ok got it loaded…. This is probably a dumb question but I ran into it earlier when I tried to print from other code… When I get it all loaded and click print, it says “heating extruder”, but never heats it up. How do I make it actually heat it up? When I was running other things through the slicer, it would say heating extruder and actually heat up. Even if I try to manually check it on, it won’t start. What’s going on?