Home / Forum / Builds and Things Built / What have you created with your MPCNC? / Reply To: What have you created with your MPCNC?

Profile photo of mark leinomark leino
Post count: 35
#7292 |

I will start. Adjusted my driver voltage on Z to .72v. It still clunks a little, but apparently it’s not missing steps anymore.

Just the first job I have gotten through without losing steps. I didn’t have anything so I had my wife draw something up in tinkercad quick, her name.

Took 29 minutes, but it could have gone waaaayyy faster, I had a 1mm depth of cut, and 10mm/s rough, and 15mm/s finish with depth of .3mm. Gotta start somewhere.