Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

New Home Forum Software Development Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

#7302
Profile photo of Leo69
Leo69
Participant

I just made some changes so I guess were up to v5. The laser power ‘S’ values will now go out to 4 decimal places for better grayscale resolution on high powered lasers. This is equal to what the PicLaser software does and should help people like our friend Andrew who’s laser maxes out at 30

@Bryan: I’m tired so I’ll post source on GitHub tomorrow.

@Andrew: Please don’t post any further messages on this thread unless they’re about img2gcode. If you have a problem related to your hardware then please start a new thread. This one is getting cluttered with off-topic posts.

thanks