Home / Forum / Builds and Things Built / What have you created with your MPCNC? / Reply To: What have you created with your MPCNC?

Profile photo of mark leinomark leino
Post count: 35
#7336 |

I tried printing pcflyers dust shoe twice, and twice it failed, 2 hours into 6 hours….

So why not cut it out of wood?

Would be a little better with square corners versus the radiused edges with a square end mill. Only took 40 minutes! Could have been faster. Probably should remember to put tabs in next time, it gets a little scary at the end.

James- Thanks for that. I tried doing that once, and it crashed my computer, so I figured it must not have been the right way. But I will try again with something a little more simple than last time I tried.