Home / Forum / Troubleshooting / Hot end temp – very high value. / Reply To: Hot end temp – very high value.

Profile photo of JeremyJeremy
Post count: 17
#7344 |

It seems that my low cost Geeetech Ramps 1.4 thermistor may be the problem. Anyone know what Temp Sensor I should set it to in marlin Configuration.h?
#11 didn’t work,
#1 was suggested on the Geetech Wiki for markin settings, but it only read 24c when melting ABS

I really don’t want to compile this 100 times to try them all.

Thanks again for your help.