Home / Forum / Hardware / Clip On Z Tower Connections Mount / Reply To: Clip On Z Tower Connections Mount

Profile photo of Leo69Leo69
Post count: 344
#7774 |

Nice, clean, versatile. Great job guys. I have a 4-pin XLR on my laser also and I just ordered a 12-pin XLR connector to create something similar for an extruder set-up. I also ordered some cable sheath since I can’t find a suitable cable to use and I’ll probably have to make my own. Anyone have any ideas? I figure I can use all 12-pins on the connector (4 for extruder motor, 2 for hot end, 2 for thermistor, 2 for fan, and 2 for proximity probe) . The problem is that the hot end has higher wire thickness requirements than the other connections so I’m pretty sure I’ll have to make my own 12-conductor cable. Unless there’s something already available that I don’t know about?